ForensicsWiki will continue to operate as it has before and will not be shutting down. Thank you for your continued support of ForensicsWiki.
argus is a network flow monitor that is used to establish network activity audits. The audits are the basis of Network Forensics for many universities and corporations, providing data mining for historical network activity. Many sites use contemporary IDS technology like snort and/or Bro to generate events and alarms, and then use the Argus network audit data to provide context for those alarms to decide if the alarms are real problems. In many DIY efforts, snort, Bro and argus run on the same high performance device. The audit data that Argus generates is great for network forensics, non-repudiation, network asset and service inventory, behavioral baselining of server and client relationships, detecting very slow scans, and supporting Zero day events. The network transaction audit data that Argus generates has also been used for a wide range of other tasks including Network Billing and Accounting, Operations Management and Performance Analysis.
Argus/Ra 3.0.8 Installation Instructions
The Argus/Ra packages installed when using apt-get install are the old 2.0.6 versions, which may have problems with filter-expressions.
In order to build Argus/Ra 3.0.8 on your UNIX machine follow these commands/steps:
- sudo apt-get install libpcap0.8 libpcap0.8-dev flex bison rrdtool
- wget http://qosient.com/argus/src/argus-3.0.8.tar.gz
- tar -xzvf argus-3.0.8.tar.gz
- cd argus-3.0.8
- make && make install
- cd ..
- wget http://qosient.com/argus/src/argus-clients-3.0.8.tar.gz
- tar -xzvf argus-clients-3.0.8.tar.gz
- cd argus-clients-3.0.8
- make && make install
- the ./argus and ./ra programs can be run from the “bin” directories within the argus-3.0.8 and argus-clients-3.0.8 directories, respectively
NOTE: If you already have a different version of argus/ra installed (e.g., if you installed v2.0.6 using apt-get install), you’ll likely need to rename/remove the “/etc/ra.conf” file or else you’ll get a syntax error when trying to run ra. I just renamed it using the following command (to keep a backup just in case):
- cd /etc/
- mv ra.conf ra.conf.bak
Argus is set up as a client server relationship. Running the argus command runs the server. It will retrieve that packets from the network interface. Then argus assembles this information into binary data. Thus it is not human readable when just running the argus command. One needs an argus client in order to analyze it.
There are a few clients for argus, but the most common is ra. It reads the output steam and prints the binary records to stdout in ASCII. Then this information can be used for incident analysis and intrusion research
A typical use for argus would be to run it as a daemon and have it write the reports to an output file:
argus -d -e ‘hostname‘ -w output-file
Argus supports filtering. One can specify to include or exclude certain ports in the report. Below is an example of filtering out ICMP traffic:
argus -w output-file - ip and not icmp
When using ra to get valuable data out, one can filter the argus data even further. Below is an example of reporting only the TCP transactions:
ra -r argus.data - tcp