DeepSpar Disk Imager
Revision as of 13:11, 12 April 2007 by DeepSpar1
- The DeepSpar Disk Imager is a hardware, drive to drive, data recovery imaging device. It makes use of a fairly standard PC system but connects directly to the source drive (the drive being imaged.) Through this hardware connection, it is able to command the source drive on a low ATA register level. It thus bypasses normal BIOS calls to the hard drive. Standard BIOS / hard drive operations will not allow the retrieval of damaged or corrupted sectors as it would invariably cause a system (OS) failure. For data recovery purposes however, it is important to be able to access any available data.
- Additionally, the DeepSpar Disk Imager controls the power input of the source drive so that it can, if required, re-power the source without rebooting the system. (This is significant with highly unstable drives that will continually “hang.”)
- To control and pre-configure the source drive, the DeepSpar Disk Imager makes use of specific ATA commands (see also: Technical Committee T13) as well as some vendor specific commands. This includes the ability to read sectors while ignoring ECC errors as well as the ability to send software and hardware reset commands to the drive which creates the ability to control “read timeout.” (Read timeout is a user defined amount of time in milliseconds that the hard drive will be given to read any particular sector. If the read timeout is reached before the sector is correctly read, it will be skipped. The imager then marks in its “map” that the sector was skipped so that it can be reprocessed on later passes.)
- Through the tool’s software interface, the end user is able to configure all parameters and commands that they wish the imager to use over multiple imaging passes. As previously mentioned, the DeepSpar Disk Imager stores a “map” of all the sectors from the source drive. This map allows the imager to always remember which sectors have been imaged, which were skipped, and which had errors etc. This in turn allows the imager to run multiple passes without reprocessing sectors that had been previous read correctly. It also allows the imager run imaging passes to target specific sector errors.
- Unlike forensics tools, the DeepSpar Disk Imager does not create an image file. Instead, it uses commands and techniques to image all sectors on the source drive directly to the destination drive. The image drive can then be used by any data retrieval or forensics software for file recovery or forensics investigation.