ForensicsWiki will continue to operate as it has before and will not be shutting down. Thank you for your continued support of ForensicsWiki.
frag_find is a program for finding blocks of a TARGET file in a disk IMAGE file. This is useful in cases where a TARGET file has been stolen and you wish to establish that the file has been present on a subject's drive. If most of the TARGET file's sectors are found on the IMAGE drive---and if the sectors are in consecutive sector runs---then the chances are excellent that the file was once there.
The idea of using individual sector hashes in this manner has been discussed in the forensic community for several years. Frag_find is an efficient and easy-to-use tool that perform this process.
frag_find relies on two observations about files and file systems:
- Most file systems tend to block-align files stored within the file system. So if you break up an 8K file into 16 different 512-byte blocks, then store that file in a file system, it's likely that those 16 different "file blocks" will be stored each in its own individual disk sector.
- Most 512-byte blocks within most files are "unique" --- that is, they do not appear by chance in other files. This is especially true for files that are compressed (like zip and docx files) and files that are encrypted. It is less true of files such as Microsoft Word doc files that are likely to have one or more blocks filled with NULLs or some other constant.
frag_find deals with the problem of non-unique blocks by looking for runs of matching blocks, rather than individual blocks.
frag_find is fast because:
- Initial filtering of presence/absence is done using the NPS Bloom filter implementation, an efficient memory-mapped Bloom implementation designed to be used with hash functions.
- Hashes are stored in efficient C++ structures.
- All computations are done in binary, rather than hex.
The following options are available:
-b blocksize - sets the blocksize (default is 512 bytes). -s <start> - start the image scan at <start> (default is start of image) -e <end> - stop the image scan at <end> (default is end of image) -r - prints the raw association map, in addition to the cleaned one
frag_find uses 512MB of RAM for the Bloom filter, approximately 1MB of RAM for bookkeeping, and roughly 64 bytes for every block of the target file.
frag_find is part of the NPS Bloom package, which can be downloaded from http://www.afflib.org/.
The current version is:
Just type ./configure && make && make install
The NPS Bloom Filter implementation is Public Domain.