BitLocker: how to image
There are multiple ways to image a computer with bitlocker security in place.
One can make a traditional image with the image containing encrypted information.
EnCase v6 has an optional encryption module which can decrypt the information provided the password is available.
The password is a long series of digits broken up into 8 segments.
There is no whitespace in the password including not at the end.
The password is easily recovered from a Bitlocked computer provided it can be logged into.
Thus the basic steps are:
1) Make a tradition image 2) Recover the password, this can be done by booting the original computer, or by creating a clone and booting the clone. (booting from a clone has not been tested at this time.) 2.1) Once booted log into the computer 2.2) Use the bitlocker control panel applet to display the password. This can also be done from the command-line. 2.3) record the password 2) Load the image into EnCase v6 or higher with the Encryption module installed 3) You will be prompted for the password. Simply enter it and continue. 4) If you prefer to have an un-encrypted image to work with other tools or share with co-workers, you can "re-acquire" the image from within EnCase. The new image will have unencrypted data. 4.1) After adding the encrypted image into your case, simply right click on the drive in the left panel and select acquire. Select "do not add to case". You will be presented a dialog window to enter new information about the image. Make sure the destination you select for your new image does not exist.