ForensicsWiki will continue to operate as it has before and will not be shutting down. Thank you for your continued support of ForensicsWiki.
How to intercept ATA commands using AoE
ATA over Ethernet (AoE) is a network protocol designed for accessing ATA storage devices over Ethernet networks.
This "How To" explains the process of using ATA over Ethernet protocol to intercept ATA commands from a Linux system (called Linux client) using Wireshark for diagnostic and testing purposes.
Linux server - Linux client configuration
First, make sure that Linux server and Linux client are connected to the same network and can exchange packets with each other.
Make sure that your server has vblade tool installed. Then run the following command:
# vblade 0 0 eth0 /dev/sda
- eth0 - your network interface;
- /dev/sda - a block device you want to be accessible through a network.
Make sure that your Linux client has aoe tools installed. Then run the following command:
# modprobe aoe
Make sure your vblade device is available on the client by running:
The following block devices would be available:
- /dev/etherd/e0.0 - the whole disk (corresponds to /dev/sda on the server);
- /dev/etherd/e0.0p1 - first partition on the disk (corresponds to /dev/sda1 on the server);
- /dev/etherd/e0.0p2 - second partition on the disk (corresponds to /dev/sda2 on the server).
Intercepting ATA commands
Launch Wireshark on a client and start a capture on eth0. You can apply the following display filter to analyse AoE packets only:
eth.type == 0x88a2
Here is a screenshot of grml client running in VirtualBox: