ForensicsWiki will continue to operate as it has before and will not be shutting down. Thank you for your continued support of ForensicsWiki.
Difference between revisions of "JTAG Huawei TracFone M865C"
|Line 98:||Line 98:|
=== References ===
=== References ===
Latest revision as of 01:16, 12 September 2013
JTAG Huawei TracFone M865C (Ascend II)
This phone is supported by the Cricket Network and Tracfone. This uses a Qualcomm 7627 600 MHz (S1) Processor and comes standard with Android version 2.3. This phone is unsupported by RIFF Box for the JTAG process for resurrector.
What you need:
- Riff Box
- USB to Micro USB cord
NAND Dump Procedure
- Disassemble the phone down to the PCB.
- Connect the RIFF box to the PC via USB.
- Connect the RIFF box to the PCB via the JTAG pins.
- Connect the PCB to a Micro USB cord and power via a power supply.
- Start the "RIFF box" software.
- Power the PCB.
- Dump the NAND.
The TAPS are located under the battery, behind the Huawei phone label. The phone will be powered by a Micro USB cord from an AC battery charger.
The TAPS order is as follows:
- 1=Not Used
For the TAPs, the Huawei-8650 was utilized, pictured above. The TAPS on the M865C are located in the same location as the 8650. See below for TAPS locations.
After the wires are connected to the board, the phone is powered by the USB connection. Plug the Micro USB into the USB connection on the device and then plug the phone into a wall outlet. The phone should respond with the vibrator switch activating for less than a second.
Launch the Riff Box JTAG Manager and use the following settings:
- JTAG TCK Speed = RTCK
- Resurrector Settings= Huawei U8650
- Auto FullFlash size
- Ignore Target IDCODE during Resurrection and DCC Loader operations
Then connect and get the ID, you should receive the dead body signal. Then read the memory. JTAG complete.
The phone has a 512 MB NAND flash memory chip which should take approximately 30 minutes to download.